Flotec FP7100H-04 Скачать руководство пользователя страница 2

Safety

2

READ AND FOLLOW 

SAFETY INSTRUCTIONS!

This is the safety alert symbol. When you see

this symbol on your pump or in this manual,

look for one of the following signal words and be
alert to the potential for personal injury.

warns about hazards that will cause

serious personal injury, death or major property
damage if ignored.

warns about hazards that can cause

serious personal injury, death or major property
damage if ignored.

warns about hazards that will or can

cause minor personal injury or property damage if
ignored.
The label NOTICE indicates special instructions
which are important but not related to hazards.
Carefully read and follow all safety instructions in
this manual and on pump.
Keep safety labels in good condition. 
Replace missing or damaged safety labels.

1. Read this manual carefully. Failure to follow

these Instructions could cause serious bodily
injury and/or property damage.

2. Consult installer or licensed plumber for correct

relief valve. Install system according to local
codes. 

3. Always test water from well for purity before

using. Check local health department for testing
procedure.

4. Before installing or servicing tank, BE SURE

pump electric power source is disconnected.
Release all water pressure before working on
tank or system. Release air pressure before
removing cover flange.

5. Install relief valve in pump supply line to tank,

as close to tank as possible.

6. BE SURE pump electrical circuit is properly

grounded.

7. Remove bleeder orifices, air volume controls or

other air charging devices in existing system.

8. DO NOT USE tank as a surge suppressor.

Hazardous pressure. To prevent pos-

sible serious or fatal injury and/or damage to
equipment, system pressure must be less than 100
pounds per square inch (PSI) (689kPa) under any
circumstances. Failure to follow instruction can
result in tank blowup. If system discharge pressure
can exceed 100 PSI (689kPa), install a relief valve
capable of passing the full pump volume at 100
PSI (689kPa).

Do not allow pump, tank, or piping

system to freeze. Freezing can severely damage
equipment and may lead to tank explosion and
serious injury. Allowing tank to freeze voids tank
warranty.

FLOTEC warrants to the original consumer purchaser (“Purchaser”) of
its products that they are free from defects in material or workmanship.
If within twelve (12) months from the date of the original consumer
purchase any such product shall prove to be defective, it shall be
repaired or replaced at FLOTEC’s option, subject to the terms and  con-
ditions set forth below. Your dated proof of purchase will be used to
determine warranty eligibility.
Exceptions to the Twelve (12) Month Warranty

Ninety (90) Day Warranty:
If within ninety (90) days from original consumer purchase any Drill
Pump or In-Line Water Filter Cartridge shall prove to be defective, it
shall be replaced, subject to the terms set forth below.
Three (3) Year Warranty:
If within three (3) years from original consumer purchase any 4”
Submersible Well Pump shall prove to be defective, it shall be
repaired or replaced at FLOTEC’s option, subject to the terms set forth
below.
Five (5) Year Warranty:
If within five (5) years from original consumer purchase any Pre-
Charge water system tank shall prove to be defective, it shall be
repaired or replaced at FLOTEC’s option, subject to the terms and
conditions set forth below.
General Terms and Conditions
Purchaser must pay all labor and shipping charges necessary to replace
product covered by this warranty. This warranty shall not apply to acts
of God, nor shall it apply to products which, in the sole judgement of
FLOTEC, have been subject to negligence, abuse, accident, misappli-

cation, tampering, alteration; nor due to improper installation, opera-
tion, maintenance or storage; nor to other than normal application, use
of service, including but not limited to, operational failures caused by
corrosion, rust or other foreign materials in the system, or operation at
pressures in excess of recommended maximums.
Requests for service under this warranty shall be made by returning the
defective product to the Retail outlet or to FLOTEC as soon as possible
after the discovery of any alleged defect. FLOTEC will subsequently
take corrective action as promptly as reasonably possible. No requests
for service under this warranty will be accepted if received more than
30 days after the term of the warranty.
This warranty sets forth FLOTEC’s sole obligation and purchaser’s
exclusive remedy for defective products.
FLOTEC SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCI-
DENTAL, OR CONTINGENT DAMAGES WHATSOEVER.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF
ALL OTHER EXPRESS WARRANTIES, IMPLIED WARRANTIES,
INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
SHALL NOT EXTEND BEYOND THE DURATION OF THE APPLICA-
BLE EXPRESS WARRANTIES PROVIDED HEREIN.
Some states do not allow the exclusion or limitation of incidental or
consequential damages or limitations on how long an implied warran-
ty lasts, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also have
other rights which vary from state to state.

FLOTEC • P.O. Box 342 • Delavan, WI U.S.A. 53115

Phone: 1-800-365-6832 • Fax: 1-800-526-3757 • E-Mail: [email protected] • Web Site: http://www.flotecwater.com

ATTACH ORIGINAL RECEIPT HERE FOR WARRANTY CONSIDERATION.

Flotec Limited Warranty

Содержание FP7100H-04








Отзывы: