FLORABEST 280272, Инструкции по эксплуатации и безопасности

Страница: 10 / 39

10 GB/IE/NI
Clean the pressure
sprayer
Unscrew the spray nozzle
7
.
Clean the spray nozzle
7
under running
water.
If the spray nozzle
7
is clogged,
clean it by pushing a needle through it.
Flush through the pressure sprayer,
pipes and tubes with water.
Clean the surfaces of the product with
a moist cloth.
Clean the suction hose
Clean the suction hose
12
as follows:
Loosen the union nut of the suction hose
9
on the container
5
.
Pull the suction hose
12
out of the
tank
5
.
Clean the suction hose
12
under running
water.
After cleaning, insert the suction hose
12
back in its opening on the tank
5
.
Tighten the union nut
9
hand-tight.
Store the pressure
sprayer
Release any residual pressure still present
in the container after use. To do this,
pull the safety valve button upwards
until you can no longer hear the hiss of
escaping air.
Thoroughly clean the device and allow
it to dry before you put it away for the
winter. This will avoid frost damage.
Clean the pressure sprayer before storing
it away.
Remove any leftover spray product from
the tank and the pipes.
Store the pressure sprayer in a dry,
dust-free place.
Troubleshooting
If the measures listed below are not success-
ful, contact the manufacturer.
= Fault
= Potential causes
= Remedies
No pressure is established in
the tank.
The pump is not firmly screwed into
place.
Screw the pump firmly into place.
The sealing ring of the pump has not
been greased.
Grease the sealing ring of the pump.
Spray nozzle does not spray.
No pressure present.
Generate pressure using the pump.
The spray nozzle is blocked.
Clean the spray nozzle.
No spray in the tank.
Fill with spray.
Filter is blocked.
Clean the filter.
Disposal
The packaging is made entirely
of recyclable materials, which
you may dispose of at local
recycling facilities.