8
Never charge a GEL battery with a non suitable recharger. Strictly
follow the instructions supplied by the batteries and recharger
manufacturer.
In order not to cause permanent damages to the batteries, it is
necessary to avoid their complete discharge, providing for the
recharging within a few minutes after batteries discharge signal
starts blinking.
Never leave batteries completely discharged even if the machine is
not used. In case of traditional batteries, please check the electrolyte
level every 20 recharging cycles and eventually fill them up with
distilled water after having carried out a complete recharge.
Danger of gas exhalations and emission of corrosive liquids. Fire
danger: do not approach with free flames.
BATTERIES DISPOSAL
It is compulsory to hand over exhaust batteries, classified as
dangerous waste, to an authorized institution according to the
current laws.
BATTERIES CHARGE LEVEL INDICATOR
Activating the push button of the brush (2) the signal lamp of the
battery charge level (1) will come on.
When the signal lamp is in
green colour
it means that the battery
charge level is
sufficient
for the functioning of the machine.
If the signal lamp is in
red colour
it means that the battery charge
level is
insufficient
for the functioning of the machine and it is
necessary to recharge immediately the batteries (see under
"BATTERIES RECHARGING”).
SQUEEGEE ASSEMBLY
With the squeegee support lowered, slide the two stud bolts (1)
placed on the upper part of the squeegee inside the slots on the
support. Block the squeegee by rotating the lever (2) clockwise.
Insert the squeegee hose (3) into its coupling, respecting its position
as indicated in the figure.
ADJUSTMENT OF THE SQUEEGEE HEIGHT
The squeegee must be adjusted in height depending on the rubber
wear. In order to guarantee a perfect drying during the operation, the
lower blade of the rear squeegee rubber (4) must work slightly bent
backwards (operator side) in uniformed way in all its length.
Acting clockwise upon the two registers (5) it is possible to increase
the bending of the rubber. Acting counterclockwise it is possible to
decrease the rubber bending.
A label placed near the two registers (5) indicates rotation sense to
increase or reduce the height.
Note: The wheels of the squeegee support must be adjusted through
the registers (5) at the same height so that the squeegee works
parallel to the floor.
ADJUSTMENT OF THE SQUEEGEE INCLINATION
In case of need, to increase the rubber bending in the central part, it
is necessary to tilt the squeegee rotating counterclockwise the
register (6). To increase the rubber bending on the squeegee
extremities, rotate the register clockwise.