10
temperature of 50°C. Add the liquid detergent in the percentage and
conditions foreseen by the manufacturer. To avoid excessive foam
presence, which could cause problems to the suction motor, use the
minimum percentage of detergent. Screw down the plug to close the
tank.
Use always low foam detergent. To avoid foam presence, before
starting working operation, introduce into the recovery tank a
minimum quantity of anti-foam product.
Never use pure acid.
FLOOR CLEANING
CONNECTION OF THE BATTERIES TO THE MACHINE
Plug in the batteries connector (1) to the machine connector (2),
placed in the rear part of the machine
STARTING OF THE MACHINE
1.
Press the switch ignition 1/0 (1).
2.
Check that the signal lamp battery charge level is in green
colour. If the red colour appears, it is necessary to proceed for
the batteries' recharge (see under “BATTERIES RECHARGING”).
3.
Press the brush motor switch (3).
4.
Press the suction motor switch (4).
5.
Press the solenoid valve switch (5).
6.
Acting upon the brush base lifting pedal (9) lower the brush
base.
7.
Acting upon the solution valve lever (7) open and adjust the
solution detergent flow.
The water starts to flow automatically when the brush motor is
activated.
On the instrument board the indicator of the solenoid valve
switch (5) will turn on.
8.
Activating the levers drive control (6) the machine will start
moving, the brush starts to rotate, the solenoid valve activates
the water flow and the squeegee will start drying the floor.
9.
During the first meters check that the detergent solution flow is
appropriate and that the squeegee adjustment guarantees a
perfect drying action.
OVERFLOW DEVICE
In order to avoid serious damages to the suction motor, the machine
is equipped with a float that intervenes when the recovery tank is
full, closing the suction hose and stopping the suction.
When this happens, it is necessary to empty the recovery tank.
1.
Hold the exhaust hose placed in the front part of the machine.
2.
Take off the exhaust plug acting upon its lever and empty the
recovery tank into appropriate containers, according to the
standard norms for the liquid disposal.
EMPTYING DETERGENT SOLUTION
To empty the detergent solution remained in the solution tank:
1.
Bring the machine to an appropriate place for tanks draining.
2.
Unscrew the solution tank cap (1).
3.
Unscrew the exhaust plug (2).
