10
QSB PC BOARD
Pulse Out - Open Collector Square Wave
WIRING DIAGRAM
QSB
ISOLATED PWR SUPPLY
12-36VDC / 12-30VAC, 50-60 Hz
12VDC OR 12VAC, 50-60 Hz
(POLARITY DOESNT
MATTER)
Coil A & B
(Non-polarized)
SIGNAL
GROUND
+
(+)
(-)
Power (-)
Power (+)
Pulse Out (+)
Pulse Out (-)
-
+
-
OPEN COLLECTOR OUTPUT
WILL REQUIRE A PULL-UP
RESISTOR TO SUPPLY
VOLTAGE
Output: Pulse Output
ISOLATED
PWR SUPPLY
12-30VAC, 50-60Hz
/ 12-36VDC
Customer
Equipment
Open Collector
Pulse Input
Coil B
Coil A
Unpowered
Pickup Coil
WIRING DIAGRAMS
Figure 7
The wire gauge for the pulse output
cable should be between 16 to
26 AWG to properly fit in the wire
termination connector.
The pulse output ground should
be properly connected to the
customer equipment ground, while
the pulse output signal should be
properly connected to both the
customer equipment pulse input
and an external pull up resistor to
an external supply (if the customer
equipment doesn’t contain the pull
up resistor).
Содержание QSI Series
Страница 17: ...17 Figure 15 Figure 17 Figure 18 Figure 16 ...
Страница 19: ...19 NOTES ...