1
Fit desk fixing to worksurface
Follow seperate worksurface fixing installation instructions
*Flo Split Clamp shown for illustration purposes
Fit monitor arm to clamp*
2
IMPORTANT
Ensure that arm is
pushed fully down
onto clamp
IMPORTANT
Install monitor cables into cable management features
7
IMPORTANT
Ensure you leave enough
free cable to avoid stretching
or snagging at all positions of
arm movement and monitor tilt
Attach monitor mount plate to monitor
3
5
Turn adjuster screw until monitor
‘floats’ in all height positions
Adjust arm to suit weight of monitor
Lighter
monitor
Heavier
monitor
90
˚
approx
90
˚
approx
Adjustment will be easier and
more precise if arm is positioned
as shown whilst adjusting
USEFUL TIP
To remove monitor
DYN-013-010-INST-A FEB2012
PUSH
IMPORTANT
Raise arm to uppermost
position before removing
monitor otherwise it may
spring up when unloaded
Arm setting indicator
USEFUL TIP
When installing similar
monitors on a large
quantity of arms you
can save time by reading off
the indicator setting of the first
installed arm. This will give you
a guide to the setting for the
other arms. You can quickly
‘dial in’ to the same setting,
then if necessary, fine tune
the adjustment to balance
the monitor
6
Ensure that portrait / landscape
action is returned to vertical position
Mount monitor to arm
4
SCREWS
OVER-INSERTED
SCREWS
UNDER-INSERTED
4 x
4 x
Do NOT exceed maximum
recommended load
9kg/19.8lb
It is the responsibility of the installer to
ensure all mounting screws are properly
engaged with a minimum of 4 x 360˚
turns into the display.Under or over
insertion may cause damage to the
equipment or injury to personnel
cl
ick
!
9
Using your Flo arm
Once it has been correctly set up, your
Flo arm permits you to easily position
your monitor wherever you want it with
fingertip control
The monitor can easily be swivelled from
landscape to portrait orientation
Ensure you have allowed enough free cable for screen rotation
DYN/013/C25
Top mount clamp 12-25mm
DYN/013/AS11
Through desk mount
DYN/013/AS09
Flo Split Clamp assembly
Do not overtighten
Monitor tilt action
8
Most monitors will automatically balance in the
Flo tilt head. If your monitor ‘droops’ you can add
a little more friction using the head friction screws
Tighten screws evenly each side
