Through Desk Fixing
Through Desk Fixing for Flo Monitor Arm
DYN/013/AS11/K
•
Do not use this product for any purpose other than
that for which it was designed.
•
Ensure desk/work surface is suitable to take the
weight of the arm/s and monitors
•
Care should be taken to avoid trapping fingers.
•
Supported weight must not exceed 9Kg (19.8lb)
per arm.
•
Ensure all screws are tightened and occasionally
adjust if needed.
•
Ensure arm is pushed fully down onto clamp before
installing the monitor
•
Clean with a damp cloth, NO solvents.
•
The use of power tools, lever bars or excessive force
during the installation, or re-configuration of the
product will invalidate your guarantee.
•
Failure to observe the recommendations in the use,
and configuration of these products may affect your
guarantee.
WARNING
MAINTENANCE and INSPECTION
DISCLAIMERS
DYN-013-002-INST-B MAY2012
Fixing stud
38 mm nylon washer
M12 washer
Nut
Spigot
Ring
Ø12mm hole
63 mm nylon washer
63 mm spreader plate
DO NOT attach the
monitor before fully
assembling arm onto
through desk fixing
Use screwdriver or similar
tool to hold Spigot in place
while tightening nut
underneath the desk
