page 19
Manual MK23 V 1_09 Z33
Contents
E
XAMPLE
SKF
M
ODE
(S
ECONDARY PIANO
K
EY
F
UNCTIONS
)
H
OW TO ENTER
C
ONTROLLER NUMBER
91
(M
IDI
R
EVERB
)
TO KNOB
K2:
Press button
Mode
and button
ON
. All four buttons
Prog B1 B2
shine red continuously and Mode
starts blinking red. SKF Mode is now active. The display shows
.
Press and hold the black piano key “Cont Set” dis’’’ (D#6). Hold this key for the whole setup process.
Display:
Briefly spin the rotary knob K2. The display shows
then
Enter the Controller number using the “Numeric Keys”. Press key 9 then press key 1 for Controller 91.
A short beep sounds after pressing the keys.
Release the black piano key “Cont Set”.
Two beeps in rising intonation signal that the new setting has been saved successfully.
Exit SKF Mode with the button
Mode
.
Now you can change the Reverb intensity of the external sound source with the rotary knob K2 while
playing.
S
YNCHRONIZE KNOB POSITION AND EXTERNAL SOFTWARE
:
The LED is red if synchronized. If you change settings in the external software (with mouse or touch
screen etc) the LED goes off. Move the knob to synchronize, the LED lights red again.
Most external Software reacts immediately to a short movement of the physical knob and "jumps" to
the current knob position. Some software allow to "seek" and "pickup" the position. Sometimes both
ways are available.
Tip:
To enter longer numbers use Keys 10-16. For example: keys 12 and 7 for the number 127.
We recommend saving your current settings before quitting the Setup Mode with B-2 Setup Store.
Please note:
MK23 Imperial 97: MIDI Note Nr. 6 – 14 no aftertouch available.
