Flismaskin 1500, Руководство пользователя

Страница: 4 / 20

GENERAL
8,5cm
. Intended use
The shredder is designed solely for shred-
ding/chipping all kinds of newly cut tree
branches of diameter up to 8.5 cm.
. Restrictions
You should not use the shredder for shred-
ding/chipping metal, stones, plastics. If you
are going to shred tree roots check that the diameter is less than
8.5 cm and remove all earth, sand and stones.
Before using the machine for the first time, check the maximum en -
gine speed by screwing in/out the screw which controls the position
of the throttle lever so that it is positioned as in the diagram.
(fig. 3)
After the first hour’s use check that the bolts of the blades and
counter blade are firmly fixed and that the gap between blades and
counter blade is 0.5mm (half a millimetre). Adjust in the slots if nec-
essary and fix the bolts .(fig. 2a, 2b)
. Description of the Machine
The shredder is a machine for shredding/chipping newly cut wood.
The rotor has 2 blades each with a 30 cm width and is powered by
a
gasoline engine. Transmission is through two parallel drive
belts. The shredded wood or chips are discharged through the out-
put tube by the centrifugal force of the rotor. Because of the angle
of the blades and the positioning of the counter blade branches
are pulled inside the machine automatically and no feeder belt is
required.
(fig. 1)
Manual Shredder - chipper
4