Flismaskin 1500, Руководство пользователя

Страница: 10 / 20

2. Before operating the machine
Make sure the machine stands firmly on the ground and does not
tilt in any way. The danger zone on the output of the machine must
be respected, in order to avoid serious injury by chips thrown out of
the output tube. Chips can be thrown a distance of 12 meters, so
onlookers must remain behind the direction of throw or at least 12
meters away from the output tube.
Before using the machine for the first time, check the maximum en -
gine speed by screwing in/out the screw which controls the position
of the throttle lever so that it is positioned as in the diagram.
After the first hour’s use check that the bolts of the blades and
counter blade are firmly fixed and that the gap between blades and
counter blade is 0.5mm (half a millimetre). Adjust in the slots if nec-
essary and fix the bolts.
3. Starting and operating the machine
Start the engine at half throttle and let it warm up for about 3
minutes. (For proper use of the engine one should also read the at-
tached manual). Then put the engine on full throttle.
(fig. 9, 10)
Put the branches in the input tube and when you feel they are
pulled in by the rotating blades, let the branch go. Do not hang on
to the branch, the branch will be pulled in by the machine by itself.
Side branches with a diameter exceeding 3 cm should be sawn or
cut off and shredded separately.
Warning!
In case of emergency or any doubt, immediately activate the safety
switch (red knob) to be found by the engine.
(fig. 11)
Before starting the engine check that the bolts holding the input and
output tubes are fully tightened.
(fig. 12, 13)
Manual Shredder - chipper
10