Install Camera
CP-6408-21-I QIG
5
© 2019 FLIR, Inc
Page
14-Pin Ter m inal Block
Pin
Definition
Pi
n
Definition
1
Audio-Out
8 Not used
2
Ground (Audio I/O)
9 Alarm-In 4
3
Alarm-Out A1
10 Alarm-In 3
4
Alarm-Out A2
11 Alarm-In 2
5
Alarm-Out B1
12 Alarm-In 1
6
Alarm-Out B2
13 Ground (Alarm I/O)
7
Not used
14 Audio-In
4.Configuration Steps
The camera’s web interface can be accessed by browsers such as Explorer,
Chrome, Firefox, etc.
Configure for Networking
By default, DHCP is enabled on the camera and a DHCP server on the
network assigns the camera an IP address. If there is no DHCP server on
the network, the IP address defaults to 192.168.0.250.
To manually specify a different IP address for the camera or to configure
other networking settings, you can use either the FLIR Discovery Network
Assistant (DNA) tool or the camera's web page.
Note
For more information about using the DNA tool, including
how to configure more than one camera at the same
time, see the
DNA User Guide
. While the software is
open, click the Help icon
.
Make sure the camera and the PC are on the same network.
To configure the camera for networking using the DNA tool:
a. Run DNA
. The Discover List appears, showing cameras on the
network and their current IP addresses.