CM-6405 / CM-6408 Quick Install Guide Revision 120
December 2021
This document does not contain any export-controlled information.
Separate Base from Bracket
4 Connect the Camera
To install the camera, Teledyne FLIR recommends connecting the camera on a
bench or in a lab and configuring it for networking before mounting and aiming it.
However, circumstances can dictate adjusting the sequence of the steps. For
example, you can mount the camera before configuring it for networking, or
connect the camera before mounting it.
Warning
The camera itself does not have a power on/off switch. Do
not supply power to the camera until you have completely
finished connecting it.
Connectors
Connector
Connection
1
RJ-45
Two LEDs
Attach a Cat 6 cable from the network switch to the RJ45 connector for a
10/100/1000 Mbps Ethernet and IEEE 802.3af class 0 PoE connection.
Ethernet is required for streaming video and for configuring the camera.
The green link LED indicates a good network connection. The orange
activity LED flashes to indicate network activity.
Warning
The PoE unit and all interconnected equipment must be installed indoors within the same
building, including all PoE-powered network connections, as described by Environment A
of the IEEE 802.3af standard.
