FLIR M-Series, Руководство по установке

Страница: 13 / 22

Installing M-Series Camera Systems
432-0003-60-12 Version 100 May 2017 13
5. Insert the JCU into the hole and secure by turning the 4 corner screws clockwise. Rotate each
screw one full turn and ensure the mounting clamps are rotated outward from the JCU housing.
Tighten the screws to draw the mounting clamps up against the mounting surface and then
tighten another quarter or half turn. Do not overtighten the screws.
Mounting the JCU to a Thin Panel
As shipped from the factory, the JCU can be mounted to
dash thicknesses ranging from 0.79 cm to 4.45 cm (0.31 in.
to 1.75 in.). The clamps are set with the small foot on the
clamp facing away from the panel and toward the front of
the JCU, as shown below.
If you intend to mount the JCU to a panel of 0.79 cm (0.31
in.) thickness or less, remove the clamps from the mounting
screws, turn them around and thread them back onto each
of the four screws. In this configuration, the clamp foot faces
the rear of the mounting surface and allows the clamp to
contact thinner panel surfaces while still allowing for proper
compression of the JCU mounting gasket to form a
watertight seal.
Electrical Connections
Watertight connectors/enclosures should be used on each of the electrical connections. Table 1.1
shows the connections for the cables attached to the camera.
Installing Noise Suppression Ferrites
M-Series equipment and accessories conform to
appropriate Electromagnetic Compatibility
(EMC) regulations, to minimize electromagnetic
interference between equipment and minimize
the effect such interference could have on the
performance of your system.
Ferrites are supplied with this equipment, the
equipment was tested for compliance with EMC
limits for a digital device with the ferrites
installed.
The supplied ferrites must be installed as
close to the camera as possible. Open the
ferrite case and attach to each cable by
clicking the case shut.
Panel thickness
Foot up to 44.5 mm
Foot
Panel thickness
less than 7.9 mm
Foot
Ferrites installed on cables
under top-down riser