This document does not contain any export-controlled information.
Installation
12
427-0108-00-10 - Revision 100 - December 2020
Side Cable Exit
5. Attach an Ethernet cable from the network switch to the RJ45 connector for a 10/100 Mbps Ethernet
and IEEE 802.3at PoE+ connection. Ethernet is required for streaming video and for configuring the
camera.
6. Connect the alarm connectors, if needed.
7. If using an external DC or AC power supply, connect its wires to the system cable's two-pin power
connector.
For more information about the camera's connections,
see
8. Place the camera over the surface and securely fasten
the tapping screws clockwise into the plastic anchors.
Make sure that the camera's orientation covers the
required field of view.
Secure the Camera to the Surface
Related Documentation
·
CB-WLBX-G4 Junction Box Kit Installation Guide
2.7
Aim and Boresight the Camera
Tip
Aim the camera while you are or someone else is monitoring the camera's live video on the camera
web page or in a video stream.
While supporting the camera's weight with your hand and using the T10 Torx wrench, loosen the three
locking screws and adjust the camera's pan, tilt, and rotation:
·
Retaining ring for pan adjustment (1): Rotate the camera. You can also rotate the lens base until
satisfied with the field of view. Do not exceed the ±360° pan range limit.
www.
.com
1.800.561.8187
