FLIR DPV74TLUX, Инструкция по эксплуатации

Страница: 9 / 37

- 8 -
Digital Video Security Systems
Installation
1. Use the included surface mounting template to drill
holes for the cable and mounting screws.
2. Run the extension cables through the surface
and connect the camera termination cable to the
extension cable.
3. Run the camera termination cable through the
camera base.
Surface Mount
If running the cable through the side conduit (side
conduit is 1/4” diameter), perform the following
instead of steps 2 and 3:
a. Remove the rubber gasket under the camera base.
b. Unscrew the side conduit cap using a flat-head
screwdriver or coin.
c. Run the camera cable through the side conduit
hole. Connect the camera termination cable to the
camera cable outside the camera housing.
d. Replace the rubber gasket.
NOTE
4. Attach the camera base to the surface using the
tapping screw 4x25 (4x).
5. Use the included allen key to loosen the dome cover screws (3x) and then remove the
dome cover from the camera module.
6. Connect the camera termination cable to the camera cable. Push the cable connection
point through the camera base into the surface.
7. Attach the camera module to the camera base using the machine screws M4x10 (3x).
Go to “Adjusting the Camera” on page 11.
Ensure the rubber gasket is firmly attached to
the camera base to ensure the weatherproof
rating of the camera.
Camera
Termination
Cable
Camera
Cable
Rubber
Gasket
Tapping Screw
4x25 (4x)
Camera
Base
Camera
Module
Machine Screw
M4x10 (3x)
Dome Cover
Do not remove the protective film on the dome cover until the installation is
completed.