FLIR DPV74TLUX, Инструкция по эксплуатации

Страница: 12 / 37

- 11 -
Digital Video Security Systems
Adjusting the Camera
1. With the dome cover removed, you can adjust the camera viewing angle, zoom/focus, LED level, and
OSD.
• (Optional) Connect the included video test cable to the
Video Test
connector to output the video
to a BNC test monitor.
• To adjust the viewing angle of the camera, tilt the lens up and down (up to 90°) or hold the sides
of the lens and twist the camera around up to 175° in either direction (up to 350°).
90°
175°
NOTE: There is a stopper to prevent the camera from twisting beyond the limits of the internal cables. Do
not try to twist the camera past the stopper.
• To adjust the zoom / focus, loosen the middle Lock screw with a philipshead screwdriver. Then
turn the
Zoom
and
Focus
screws using the included zoom/focus adjustment tool or with a small
philipshead screwdriver. Make sure to re-tighten the Lock screw when finished adjusting the lens.
• To adjust the power output to the IR LEDs, use a small philipshead screwdriver to turn the
LED
Level screw left to decrease the output or right to increase the output. It is recommended to fine
tune the IR level during low light conditions to determine the best setting.
NOTE: By default, the IR LEDs are set for maximum output. For short-range installation environments, it is
recommended to turn down the LED level.
• For details on adjusting the OSD menu, see “How to Set Up the Camera Menu” on page 13.
NOTE:
OSD menu can also be controlled using a UTP controller (Pelco C protocol; accessory model number:
ACCUTC1).
2. Replace the dome cover and tighten the dome cover screws (3x).
3. Remove the protective film from the dome cover.
Test Monitor
Output OSD
Joystick
LED
Level
175°