background image

 

... the right weigh 

 

 

FRD-100 BL Manual 

page 2 of 7 

 

1.

 

SAFETY INFORMATION ................................................................... 2

 

2.

 

CHARACTERISTICS.......................................................................... 3

 

DISPLAY ........................................................................................................... 3

 

MECHANICAL .................................................................................................... 3

 

ELECTRONICS ................................................................................................... 3

 

CABLE ASSIGNEMENT ........................................................................................ 4

 

3.

 

OPERATION NOTES ......................................................................... 4

 

INSTALLATION NOTES....................................................................................... 4

 

NORMAL BEHAVIOUR......................................................................................... 5

 

STANDARD DATA PROTOCOL DESCRIPTION........................................................ 5

 

4.

 

SERVICE AND CONTACT INFORMATION......................................... 7

 

 
 
 

1. Safety Information 

All products of this series are developed, manufactured and tested in accordance with 
the  applicable  industry  safety  standards.  If  these  products  are  properly  installed, 
operated  and  maintained  according  to  the  applicable  technical  instructions,  drawings 
and specifications, no hazard exists in the normal and intended use of these products. 
 
 

 

 
 

General Safety Guidelines 

 
The following general safety guidelines apply to all Flintec - products: 
 

 

All applicable safety and accident prevention recommendations must be 
observed (VDE 0100 and VDE 0113). 

 

 

All installation, start-up and maintenance work must be carried out by 

qualified 

service personnel 

only. 

 

 

An easily accessible power outlet must be located close by for devices equipped 
with a main power cord and plug. 

 

 

An easily accessible MAIN POWER ON/OFF switch must be provided for 
equipment with permanent electrical connections.

 

Содержание FRD-100 BL








Отзывы: