10
The pushrods are made of wood and are to be assembled as shown in the drawing.
Attach the rod to the servos with a anap keeper, the same as the aileron pushrods. The
throttle pushrod is just a length of 3/64" wire sliding in the preinstalled tube. Be sure
to adjust it so that you have full movement of the carburetor without stalling the servo.
Check the size of the servo holes in the fuselage servo tray; alter as necessary. epoxy
into the fuse, and install the servos. Tutn on the system and check the operation of the
servos; they shuold all work without interfering with each other or the fuse.
Attach the rod to the horn, set the surface and the servo to neutral, and mark the length
on the ftont rod. Remove the rod, make a rightangle bendin the wire, and cut off the
escess.
The bent rods included are for the servo ends and the threaded todsare for the back ends.
After mounting the control horns on the rudder and elevator (use the squares of clear
plastic between the horn and the surface, and between the nut plate and the surface) you
