Flexco RBP1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 24

10
RBP1 Belt Positioner
6.4 Roller Replacement Instructions
Section 6 - Maintenance
2. Remove roller by unbolting (4) Roller Retainers (Fig. 1).
1. Remove tension from belt. Use a Flex-Lifter or other appropriate lifting equipment to lift the belt
approx. 3" (75mm) off the trainer.
3. Install new roller and re-bolt Roller Retainers (Fig. 1). Confirm roller turns smoothly.
4. Lower the belt. Ensure belt completely contacts rollers. Lower brackets if there is not good contact.
Tighten all bolts.
5. Refer to pre-op checklist (page 8) before running the conveyor. If belt is still mistracking, refer to
Section 5.2 on page 8.
CAUTION: Components may be heavy. Use safety-approved lifting procedures.
Physically lock out and tag the conveyor at the power source
before you begin cleaner installation.
Tools Needed:
- Tape measure
- 5/16" (8 mm) wrench or crescent wrench
Fig. 1
Roller Retainer
Roller Retainers
Roller Retainer
(hidden)