6
Specifications and Technical Data –
Pneumatic Accessories and Connections
WARNING: Read Section titled “Safety Instructions”
The Flexco
®
Power Set
™
Air Control Assembly consists of an Oiler, Filter Unit and Pressure Gauge. This regulator system was
configured to work specifically with the Power Set System.
AIR CONTROL ASSEMBLY SPECIFICATIONS
Regulator/Filter ............Parker No. PS901P Filter or equivalent
Oiler.............................Parker No. F442 Oil or equivalent: Petroleum based non-detergent I.S.O. Grade #32
WARNING:
The Air Control Assembly regulator is designed to operate up to 120 PSI. Do not connect this
regulator to an air source over 120 PSI. The Power Set regulator pressure relief safety value will activate.
Note:
Oiler is shipped empty. Prior to operating tool, fill oiler with oil as indicated above. Using lubricants other than those
specified will damage the tool and void the warranty.
Note:
Change regulator filter if you are experiencing reduced airflow to the Power Set Driver. When replacing filter, clean out
filter bowl to prevent restrictions to airflow.
COMPRESSOR REQUIREMENTS
A compressor that will generate at least 9 SCFM at 85-90 PSI will satisfy the requirements for running one Power Set driver at a
firing rate of twice/second. For two Power Set drivers coming off the tee-fitting 18 SCFM is required.
Note:
Follow all MSHA
regulations and requirements for using a compressor in an underground mining environment.
USING A COMPRESSOR WITH A SURGE TANK
Power Set users can use a smaller compressor by using a surge tank. Surge tank size requirements will vary based on HP of the
compressor.
HOSE SPECIFICATIONS
Parker Pneumatic “Push-Lok” Hose ......Parker No. 831-6
Length...................................................25 feet
I.D. / O.D.............................................3/8” (10mm) / .63” (16 mm)
Minimum Bend Radius.........................3” (75mm)
Working Pressure ..................................300 PSI
Burst Pressure........................................1400 PSI
Material Construction...........................Synthetic Rubber (Note: MSHA Accepted)
Chemical Resistance..............................Petroleum hydraulic and lubricating oils, antifreeze solutions, water /oil emulsions
FITTING SPECIFICATIONS
Regulator/Filter Assembly .....................Parker No. H2E 3/8” Male Nipple 20 Series Industrial Interchange
Tee Fitting ............................................Parker No. 24 Quick Coupler, Male 20 Series Industrial Interchange
Hose Fitting to Tee Fitting.....................Parker No. H5EP Nipple 3/8” Push-Lok Hose 20 Series Industrial
Interchange
Hose Fitting to Driver ...........................Parker No. 24-5BP Coupler 3/8” Push-Lok Hose 20 Series Industrial Interchange
Power Set Rivet Driver...........................Parker No. H2E 3/8” Male Nipple 20 Series Industrial Interchange
Содержание PSRD-1
Страница 15: ...15...
