11
7. Load guide blocks with Power
Set
™
Rapid Loader
™
collated rivets
with washers.
Note: Do not use
rivets without washers.
Without
washers, misfires will occur. If a
shorter strip is needed, break off extra
rivets by bending strip at checkpoint.
8. Using a hammer, hit collated rivets
to release all rivets from plastic.
Remove plastic from guide blocks and
discard.
Note:
For optimal results operate the
driver at 85-90 PSI (approximately 6
bar). Do not exceed 120 PSI (8 bar).
9. Insert the Power Set driver nose
directly into the counter bore of the
guide block.
Make sure Trigger Lock
Dial is in the unlocked position.
The
driver nose must be completely
inserted so that the contact arm is
retracted. Pull the trigger to fire the
driver. Wait approximately 1 second
between shots to allow the driver to
fill with air.
10. Drive Rivets into center hole of
both end plates. This will anchor
fastener strip in position. Continue
driving rivets into all center holes.
Complete driving the other two rows
of rivets in the sequence shown above.
While hitting rivets keep the guide
blocks as level as possible to avoid
misfires. Hit each rivet two to four
times.
11. Remove guide block(s) and make
sure rivets are set completely. If some
rivets are not completely set, replace
guide block(s) and hit the rivets that
need to be set. Remove guide blocks
and check the rivets again. Use the
total number of hits on each rivet in
subsequent blocks. Complete belt end
by moving the block across the width
of the belt and continue driving
rivets.
12. Repeat steps 1-11 on other belt
end. Bring belt ends together and
insert hinge pin. Notch trailing edge
of belt only. Splice is complete.
Содержание PSRD-1
Страница 15: ...15...
