8
H-Type
®
Primary Cleaner with V-Tips
4.2a H-Type
©
Primary Cleaner with V-Tips
Section 4 – Installation Instructions
1. Find X and Y measurements. Find the X and Y measurement specifications for the pulley diameter. See charts
on pages 14, 15 and 16. The pulley diameter measurement should include lagging and belt.
Pulley Diameter _________mm; X = _________mm; Y = _________mm
Using the correct X and Y coordinates will position the cleaner at 15° below the horizontal plane on the head
pulley.
Fig. 1
Fig. 2
Fig. 2b
4. Locate mounting bracket position (horizontal position). To locate the
position of the cleaner mounting bracket, add 70mm to the intersecting
mark (Fig. 2b). This mark indicates the top centre of the mounting bracket.
Fig. 2a
2a. Measure head pulley shaft. Determine the diameter of the pulley shaft
and divide by 2.
2b. Put a level on top of the pulley shaft and draw a horizontal line A.
Measure down from Line A half the diameter of the pulley shaft and draw
Line B parallel from the pulley shaft (Fig. 1).
3a. Mark X dimension. Subtract the above dimension (Step 2a) from the
selected X dimension to establish the modified X dimension. With this
new X dimension measure horizontally from the front of the pulley shaft
forward on Line B and mark on the chute (Fig. 2).
3b. Determine Y dimension. From the horizontal X mark, drop a line
vertically down to the selected Y dimension and draw an intersecting mark
(Fig. 2a). This is the correct position of the centre of the pole.
Chute Mounting
70mm
