—6—
—7—
Power Belt Skiver
Power Belt Skiver Operation
For best results: Store in a clean, dry area. Do not throw or drop tool. Use only on belts between 1/4” (6.5 mm) and 1-1/4”
(32 mm) thick.
1.
Cut belt using centerline method.
NOTE: For easier skiving, clean belt and use
only sharp, undamaged blades.
2. For new tool, carefully remove the
protective coating on the blade. Turn Blade
Adjusting Screw to select desired cutting
depth. Tighten Jam Nut.
3. Adjust end wing nuts on metal fence to
move fence to appropriate setting.
4. Turn Clamp Adjusting Screw counter-clockwise to loosen grip rollers. Position edge of belt against Fence – belt should just touch
blade edge.
5. Turn Clamp Adjusting Screw clockwise to tighten Front Drive Rollers against belt. Do not overtighten or cut may be deeper than
expected. Flexco recommends testing skiver on belt sample before skiving actual belt to ensure skive depth is appropriate.
6. Note skive direction and set tool to
reverse. Once belt reaches Rear Drive
Rollers, turn Clamp Adjusting Screw
counter-clockwise 1/4 rotation.
7. When skiving, scrap cut should remain in
contact with belt. Scrap cut and Belt should
feed under Rear Drive Rollers.
8. Advance skiver in a controlled manner
across width of belt. Ensure belt is against
Fence. Advance skiver completely off belt
to complete cut. Remove scrap cut. Repeat
steps 1-8 on other belt end.
R9
BR14
R6/R8
R5½
BR10
R5/190
BR6
140
