www.flexco.com
Installing Flexco
®
BR10 Fasteners with the Electric Powered Rivet Driver
—2—
9. Attach clamp bar (B) to the tool so that
one edge of the clamp bar is over the center
of the fastener strips. Tighten clamp bar.
10. Place belt against clamp bar (B). Center
belt over bottom plates. Clamp belt to tool
with the other clamp bar (B), do not over-
tighten.
12. Remove center clamp bar. Position loose
belt end against other belt end, aligning cen-
ter lines. Clamp belt and nail in place.
13. Insert aligning bar in ends of MBRTA.
Tighten top knurled nut. Tighten lower
knurled nut to lower fasteners to belt surface.
11. Secure belt by driving double headed
nails through holes in clamp bar and into
the belt.
8. Insert black retainers between every plate
and tap with hammer.
14A. Load guide
block with individual
rivets. Reduce
installation time by
adding guide blocks
across tool.
Reduce installation
time using Rapid
Loader
™
Collated
Rivet Strips.
14B. If a shorter
strip is needed, break
off extra plates by
bending strip at
checkpoints.
Individual
Rivets
Rapid Loader™
Collated Rivets
Note: Spray guide blocks with SL5 silicone.
