Installing Flexco
®
BR10 Fasteners with the Electric Powered Rivet Driver
—3—
—2—
15. Adjust setting dial for rivet size – see chart below.
Insert the punch directly into the BR500 Guide Block.
Keeping the tool perpendicular to the base, pull the
trigger to fire the driver. Push down on the driver slightly
and maintain force on the driver until you feel the rivet
set. This should take approximately 1 to 2 seconds per
rivet depending on the length of the rivet and the type of
belt.
17. For easier troughing on belts up to 35°
trough, remove bridges between plates in
troughing area using the BR151 Bridge
Removal Tool.
16. If all plates are not covered by guide
blocks (E), move a guide block (E) to install
remaining rivets.
18. Unlock and remove cam rods (C).
Remove nails and clamp bars (B).
19. Remove MBRTA. Remove pilot nails
and clips with a hammer. If fasteners are 1”
(25mm) or more from edge of belt, notch
belt. Remove nails from MBRTA.
Tool Setting Guidelines
Tool Setting
Rivet size range
2
A, B
3
A, B, C
4
C, C/D, D
5
D, E, F
Note: Tool settings will require adjustment for
variations in belt thickness and construction.
