6
I N S T A L L A T I O N
3 ) Insert the rear pin into the upper bore and bearing of the an gle mount. The rear
pin may not slide easily through both bearing sets. Use the cap screw to help pull
the unit completely through the bottom bearing.
It may require two people to support the arm and guide the rear pin into the
bearing sets.
4)
Install the levers at either end or the angle. These are for adjusting the
amount of force needed to move the angle and rear pin.
Tightening the lever will increase the force needed to move the joint and
loosening the lever will decrease the amount of force needed.
5)
Check all airline connections to ensure that no hoses have come loose from the
press-to-release fittings. Hoses must be completely pushed into the fittings to
lock under pressure. Check the connection by gently pulling on the hose.
6)
Install a
¼”NPT
fitting into the left (input) port of the filter assembly. It is
recommended that a 3/8"ID incoming airline be used to get maximum air flow. The
pneumatic system on the FlexArm will require a minimum of 90 -120 psi input to
perform the maximum balancing operations.
7)
The air filter is equipped with an auto drain and will automatically remove
moisture from the bowl.
REV.000
