5
0.406
4 PLACES
EQUALLY
SPACED
4.50
BOLT CIRCLE
5.50
BASE MOUNT
3/8" DIAMETER
MOUNTING BOLTS
(4 REQUIRED)
FLAT MOUNTING SURFACE
ANGLE MOUNT BOLT
WASHER
ANGLE MOUNT
I N S T A L L A T I O N
1)
Drill and tap (4) 3/8" bolt holes on a flat, smooth table or work bench.
(see Base Mount diagram below)
Base Mount pattern
2 ) Secure the Base Mount to the worktable. Slide the Angle Mount onto the shaft of
the Base Mount and secure the angle with the washer & cap screw
before inserting
the FlexArm!
The angle mount may not slide easily through both bearing sets , so
make sure the angle is straight up and down and tap lightly with a rubber mallet if
necessary.
(see Angle Mount assembly diagram below )
REV.000
