Flex S 703 BVE, Инструкция по эксплуатации

Страница: 5 / 36

1
ADDITIONAL SAFETY RULES FOR PORTABLE BAYONET SAWS
1. KEEP BLADES SHARP.
2. KEEP HANDS AWAY FROM CUTTING AREA. When sawing never reach underneath or behind the
material being cut for any reason.
3. WHEN YOU HAVE FINISHED A CUT be careful not to come into contact with the blade. Turn off the
motor immediately.
4. WARNING: EXERCISE EXTREME CAUTION WHEN BLIND CUTTING TO BE CERTAIN THAT
THERE ARE NO FOREIGN OBJECTS SUCH AS ELECTRICAL WIRE, CONDUIT, PLUMBING PIPES, ETC.,
THAT MAY COME INTO CONTACT WITH THE BLADE.
5. SOME WOOD CONTAINS PRESERVATIVES WHICH CAN BE TOXIC. Take extra care to prevent
inhalation and skin contact when working with these materials. Request, and follow, any safety
information available from your material supplier.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
ASSEMBLY
ANTI-SPLINTER BASE INSERT INSTALLATION
The anti-splinter base insert is used to reduce chipping and splintering of the top fibers of plywood,
paneling, and other splinter prone materials. When this insert is used it is not necessary to have the
good or finished side of the work down during the cutting operation.
Install the insert as shown in figure 1. NOTE: When using the anti-splinter insert, the base should be set
to the forward-most position, Fig. 9.
ANTI-MAR PLASTIC SUB-BASE INSTALLATION
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
The anti-mar plastic sub-base is used when cutting on finished surfaces to prevent the normal metal
base from scratching, gouging, or otherwise marring the surface of the material to be cut.
To install the plastic sub-base, remove the six screws from the bottom of the base, remove the metal
sub-base, place the plastic sub-base on the saw, and reinstall the six screws. Be sure to save the metal
sub-base for reuse.
BLADE INSTALLATION
1. Open front guard A, Fig. 12.
2. Remove anti-splinter insert if installed.
3. Gently squeeze the switch trigger until the blade shaft moves slowly and stop the motor when the
blade shaft is at or near the bottom of its stroke, Fig. 6.
CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
TECHNICAL SPECIFICATIONS
Voltage supply ....................................... 230 V A – weighted noise level
Power consumption.............................. 705 W Sound pressure level............................ 84 dB
Power output ........................................ 460 W Sound power level................................ 97 dB
Frequency ......................................... 50/60 Hz WEAR EAR PROTECTION!
Strokes per minute (max.)............... 500-3100 Typical Mean effective Acceleration.......... 5 m/s 2
Stroke ............................................... 25.4 mm Weight
Max. cutting depth (steel).................... 20 mm Without case and accessories ............. 3.0 kg