RS 29 18.0
17
Adjusting the cutting support
WARNING!
Remove the battery before carrying out any
work on the power tool.
The cutting support should always rest on
the material when sawing so as to avoid
excessive vibrations.
It is possible, for example, to limit the saw
blade cutting depth by adjusting the cutting
support.
Press the cutting support lock down (1.).
Adjust the cutting support to the required
depth (2.).
Press the cutting support up as far as it
will go.
Working with orbital stroke
CAUTION!
Press the orbital stroke switch only when
the saw blade is fully stopped!
– The saw blade only performs horizontal
movements when orbital stroke is
switched off. This is suitable primarily for
cutting metal.
Also use this setting if you require a very
good cutting finish when sawing wood.
– The saw blade performs horizontal and
vertical movements (oscillating
movements) when orbital stroke is
switched on. This is suitable primarily for
cutting wood at high speed. The quality of
the cutting edge is worse.
To switch on orbital stroke:
Press the orbital stroke switch down as
far as it will go.
To switch off orbital stroke, press the
switch up as far as it will go.
Switching the power tool on/off
Press the switch-on interlock (1.).
Press and hold down the switch (2.). The
power tool starts.
Release the switch-on interlock.
The power tool switch allows the operator to
increase the stroke rate slowly up to the
maximum setting.
The LED illuminates the working area when
the power tool is switched on.
To switch off the tool:
Release the switch.
Akku-Säbelsäge RS 28-18.0.book Seite 17 Freitag, 3. Juli 2015 2:41 14
