Flex DGE 8-32, Оригинальная инструкция по эксплуатации

Страница: 22 / 278

DGE 8-32
22
Continuous operation with engaged switch
rocker
CAUTION!
The electric power tool features a starter
interlock. In other words, the electric power
tool will not start running again if still
switched on after a power failure.

Push the switch rocker forwards (1.) and
engage by pressing the front end (2.).
Switching on electric power tool after a
power failure:
– Switch off the electric power tool.
– Switch on the electric power tool again.
Switch off the machine

To switch off the power tool, release the
switch rocker by pressing the rear end.
Overload protection

If an extremely brief overload occurs, the
overload protection prevents damage to
the motor by automatically switching the
device off.
For further information on the manufacturer’s
products go to www.flex-tools.com.
Disassamble plastic hood

Loosen the screws and remove the
plastic hood.
The spindle neck with a diameter of 43 mm
(A) is exposed. TThe machine can be
clamped to it when stationary.
Operating instructions

Do not place the grinding tool on the
workpiece until the power tool has
reached full speed.

To obtain a good grinding result, move
the grinding tool evenly over the surface
which is to be ground down. Do not apply
excessive pressure.

When the power tool is switched off, the
grinding tool continues running briefly.
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.