16
MAIN WING INSTALLATION
Required Tools and Fasteners
: M3x18 Thumb Machine Screw (2)
1.
Remove the canopy from the fuselage by pulling the latch to the rear and lifting the canopy from the fuselage.
2.
Insert the main wing tube into the fuselage and roughly center.
3.
Slide the left and right wing panels onto the tube. The servos and linkages are mounted on the underside of the wing.
4.
Connect the all-in-one servo lead to the receptacle in the wing.
5.
If you have a night version, connect the wing JST to the LED controller JST as shown in the picture below.
6.
Fully seat the wing into the fuselage while being careful to align the wing mounting tab with the slot in the fuselage. Be sure to avoid
pinching any wires during this process.
7.
Secure each wing to the fuselage using an M3x18 thumb screw on the inside of the fuselage (you can use a Phillips screwdriver if desired).