3
•
Room Temperature & Air Humidity:
Allow the Fibo Wall panels to adjust to room temperature and air humidity for at least 72 hours
before installation, and read the Fibo Seal Technical Datasheet for proper handling and storage of the sealant. The panels should be
installed at temperatures no less than 18°C / 65°F and 45%RH. Panels should not be installed in areas where the temperature may
drop below freezing (0°C / 32°F). Failure to follow this recommendation could adversely affect the sealant function and change the
dimension of the panel, causing it to warp.
•
Eye Protection:
Be sure to use all personal protective equipment to ensure your own safety. To avoid eye injury, always wear
protective glasses with side shields when using power tools. Also, make sure no one else can be injured by flying particles when using
power tools.
•
Fire Hazard:
Personal injury or death can result from a fire caused by flammable liquids. Cleaners or solvents can be highly explosive,
resulting in personal injury or even death when not used properly. Clean up any flammable substances immediately. Sparks or open
flames can cause flammable substances to ignite. DO NOT smoke while working on or near any flammable substances.
•
Solvent Hazard:
Follow all the manufacturer’s safety instructions for Fibo Seal, Fibo Adhesive, Fibo Clean and Fibo Wipes. Fibo
Clean is both flammable and hazardous to breathe. It may cause dizziness so make sure to have a proper ventilated room when in use.
Fibo Wipes may cause dry skin with prolonged skin contact. Personal injury can result from improper handling or use of products.
Always follow the manufacturer’s recommendations for the safe use of these products. Ventilate any work area before beginning to
apply sealant, cleaning agents or solvents.
•
Dust Hazard:
When cutting or drilling a Fibo product, use a dust collection method to minimize airborne dust particles. Always use
an OSHA approved dust mask when cutting, drilling or sanding Fibo products.
•
Power Tool Hazard:
To prevent personal injury or possible death, always follow the electrical safety recommendations for the power
tool’s manufacturer. Do not use power tools in an unsafe manner. Power tools should only be connected to a circuit protected by a
ground-fault circuit interrupter (GFCI).
•
Shock Hazard:
Never use electric power tools around water, condensation, or other liquids. Electric shock can cause severe burns,
significant injuries, and even death. If an extension cord is required always use an OSHA approved extension cord. Power cords should
only be connected to a circuit protected by a ground-fault circuit interrupter (GFCI).
HELPFUL HINTS
•
Ensure construction is correctly sized, plumb and square.
•
Allow enough time for the parts in this kit to adjust to room temperature. Recommended minimum time is set to 72 hours.
•
We do not recommend installation of this product at temperatures below 18°C / 65°F and below 40% RH.
•
Do not use stored Fibo panels as an underlayer for cutting other Fibo panels. Make sure to have another proper underlayer available.
•
Make sure the backwall is level and the corners are at 90º. For uneven walls we recommend using OSB Strips and, if necessary, extra
shims to even out.
WARNING:
•
Fumes Hazard:
The fumes from the Fibo Clean used by the installer can be harmful if used in an unventilated room. Always work in a
well-ventilated area. To keep the area well-ventilated, open windows and use exhaust fans. If adequate ventilation is not achievable or
practical, use respiratory protective equipment
CONSIGNES DE SÉCURITÉ
Si le produit est correctement installé et entretenu comme indiqué dans ces instructions, il n’y aura pas de dégâts d’eau.
ATTENTION:
Pour éviter d’endommager le produit, tout risque de blessures graves ou fatales, lire attentivement, comprendre et suivre toutes les
instructions de ce guide avant d’installer le ou les produits.
Lire et comprendre les instructions et les avertissements concernant les liquides de nettoyage et les outils utilisés pour cette
installation. Le bon usage des outils et des produits décrits dans ce guide est votre responsabilité.
GARANTIE:
Pour toute information concernant la garantie des produits Fibo, veuillez visiter fleurco.com/fibofr.
AVIS IMPORTANT:
Indique que des dommages à l’équipement ou aux biens peuvent survenir si les instructions ne sont pas suivies.
MISE EN GARDE:
Indique une situation potentiellement dangereuse qui, si elle n’est pas évitée, peut entraîner des blessures. Elle peut également être
utilisée pour signaler des pratiques dangereuses.
AVERTISSEMENT:
Indique une situation potentiellement dangereuse qui, si elle n’est pas évitée, pourrait entraîner des blessures graves ou la mort.
Utiliser les méthodes d’installation appropriées: Suivre toutes les instructions liées à la préparation des surfaces des murs. Le non-
FRENCH
/ FRANÇAIS
