FLENDER N-EUPEX DK, Руководство по сборке и эксплуатации

Страница: 16 / 68

Safety instructions
2.1 General information
16 Edition 09/2022 M3105-02en
ISO ANSI Warning
--- Warning – hand injuries
Explosion protection approval
Table 2-1: General warnings
Explanation regarding regulation 2008 No. 1597
The couplings described here are “components” in accordance with the regulation 2008 No.
1597 and do not require a UK declaration of incorporation.
Explosion Protection Directive
The term “Explosion protection regulations” used in these instructions refers to the relevant
notified standards and “The Equipment and Protective Systems Intended for Use in Poten-
tially Explosive Atmospheres Regulations” complied with in accordance with the applicable
UK Declaration of Conformity.
Protective clothing
In addition to the generally prescribed personal protective equipment (safety shoes, overalls,
helmet, etc.), also wear suitable protective gloves and safety glasses when handling the
coupling.
Using the coupling
The relevant occupational safety and environmental protection regulations must be complied
with at all times during transport, assembly, installation, dismantling, operation and mainten-
ance of the coupling.
Only qualified personnel may operate, assemble, maintain and repair the coupling. Informa-
tion about qualified personnel can be found in the legal notes at the beginning of these in-
structions.
If hoisting gear or load lifting devices are used for transporting, these have to be suitable for
the weight of the coupling.
If the coupling has visible damage, it may not be assembled or put into operation.
The coupling may only be operated in a suitable housing or with touch protection according
to applicable standards. This also applies to test runs and rotational direction checks.
Work on the coupling
Only carry out work on the coupling when it is not in operation and is not under load.
Take measures to prevent the accidental restarting of the drive aggregate. Attach an inform-
ation notice to the start switch stating clearly that work is being carried out on the coupling.
Ensure that the entire unit is not under load.