41. Continue to route supplied Chassis Harness next to
the existing wiring harness along the inside edge of
the frame rail. RECOMMENDED: Secure supplied
Chassis Harness to the existing wiring harness with
Wire Ties.
42. Once the Chassis Harness has been routed to the
rear of the truck bed, coil and secure any excess
length on the harness and tuck above the spare tire.
Secure with Wire Ties (recommended) or Electrical
Tape.
43. Plug Camera Harness connector into the Chassis
Harness connector at the rear of the vehicle.
44. Start vehicle and shift into Reverse in order to check
that all connections were made properly. If all of the
connections are correct you will see the camera
image displayed on your aftermarket mirror /
display/ NAV display.
45. Reassemble all previously removed parts.
46.
If you connected the camera to a factory 8.4”
touch screen, and the vehicle has not been
reprogrammed to “enable” the camera, have a
Chrysler/Dodge dealer program the vehicle as
follows:
Dealer Programming Instructions
PARK VIEW REAR BACK-UP CAMERA
VEHICLE CONFIGURATION
Vehicle VIN must be updated with the sales code of the
added accessory in order to enable system functionality.
Using the DealerCONNECT website and the scan tool,
complete the procedure below:
A.
Log on to
our website
B.
In the “Vehicle Option” screen under “Global Claims
System” category in the “Service” tab, enter the
VIN and add the following sales code: XAC (PARK
VIEW REAR BACK-UP CAMERA) as a “Dealer
Installed Option.”
C.
Confirm that the new sales code has been
successfully added to the VIN. With the scan tool
connected to both the internet (via Ethernet port or
wireless connection) and the vehicle, follow the
steps below:
D.
Using the scan tool select the VEHICLE
PREPARATION and then select RESTORE VEHICLE
CONFIGURATION.
E.
Follow the step by step instructions on the scan
tool to complete the Park View Rear Back-Up
Camera vehicle configuration.
48.
Start vehicle and shift into Reverse in order to
check that all connections were made properly. If
all of the connections are correct you will see the
camera image displayed on your factory 8.4” touch
screen.
49. Reassemble all previously removed parts.
CAMERA PARKLINE OPTION
The camera offers Park lines or non-Park
lines options.
Park line options:
Default setting
displays
Park lines
. To remove the grid line display,
pull back plastic convolute from end of camera
harness and connect the two green wires.
Display options:
Do not use white wires.
Green and White wires on the Camera Harness.
