STEP 10:
Remove the OE sending unit and sealing
flange from the tank. Discard the original seal ring.
STEP 11:
Thoroughly clean the tank surface where
the new lift pump will be installed. Inspect the inside
of the fuel tank for any debris. If any debris is
present, the tank must be cleaned.
STEP 12:
Install the new flange seal included with the
lift pump. Slide it up from the bottom of the pump -
sliding it all the way up to the flange. Perform this
step
before
installing the fuel level float arm.
Install the fuel level float arm onto the lift pump by
gently clipping the arm into the fuel level sensor.
STEP 13:
Install the PowerFlo pump assembly into the
tank and reinstall the retaining ring using ahammer
and punch by rotating it clockwise to the fully
engaged position. Ensure proper orientation of the
pump and fitting by aligning the alignment tab on the
lift pump cap with the marks on the fuel tank.
NOTE: Use caution when installing the pump to not
damage the float arm. DO NOT rotate the pump once
installed in the tank, you will damage the float arm or
sending unit
–
align the pump before you place it into
the tank.
