STEP 1:
Ensure you have 1/4 tank or less of fuel in the
fuel tank to allow for the tank to be easily lowered
and maneuvered. Leave enough fuel in the tank to
allow for the pump to draw fuel in immediately once
installed.
STEP 2:
Disconnect the electrical connector from the
fuel level sending unit.
STEP 3:
Loosen the 8mm hose clamp on the filler
neck and remove the filler neck from the tank.
STEP 4:
Remove the fuel lines at the front of the tank,
and
at the fuel cooler with a 3/8” and
1/2
” fuel line
disconnect tool.
NOTE: Thoroughly clean the fuel line connection prior
to removal with a rust preventative such as WD-40 or
PB Blaster. Clean the connection with compressed air
or a pick to ensure debris does not become lodged in
the fuel line during removal. Have a drain pan or
bucket ready to capture the fuel that will drain from
the system when the lines are disconnected.
PROCEDURE:
