STEP 5:
Place a transmission jack or floor jack below
the fuel tank and lightly support it. Remove the tank
straps using a 15mm deep socket. With the tank
straps removed, carefully support the fuel tank and
lower it down to the ground.
STEP 6:
Thoroughly clean off the top side of the tank
around the sending unit to avoid getting any debris
inside the fuel tank when the sending unit is
removed.
STEP 7:
Remove the fuel lines at the sending unit
with the quick disconnect tools.
STEP 8:
Using a hammer and a chisel or punch,
remove the locking ring by tapping the ring counter
clockwise.
STEP 9:
With the fuel lines and retaining ring
removed, clean any remaining debris away from the
sending unit with a vacuum and rag and avoid debris
entering the fuel tank when the sending unit is
removed. Take note of the orientation tab on the
sending unit cap, the new lift pump will orient in the
same manner as the original.
