# 4 in photo and hand tighten then snug it up with a small wrench. Note: no tape is
required this is a compression fitting.
Take other end of tube slide nut over tube then Farrell which looks like a small round
doughnut over tube then insert sleeve into tube. Push tube into side of 7000SE valve and
hand tighten then snug up with a small wrench.
Attaching your drain line:
Note: Do not attach the drain line to the elbow on the brine tank it will overflow the brine
tank. Run the drain line to a house drain, where your washing machine drain line goes is
an excellent choice, if this is not possible then you can drain into multiple areas, make sure
you always leave an air gap if going into a pipe. An air gap is an open area where
there is no standing water. Your drain line can be elevated up to 5 feet over and above
where it comes out of the valve and you can run it up to 100' away. Always follow local
codes.
Slide a 1/2" hose clamp over drain line and then slide drain line over drain hose barb.
Slide hose clamp over barb and tube and tighten the hose clamp.
Plug your power cord into a nearby outlet. Plug the metering cable coming out the back
of the 7000SE valve into the slot on the outlet side on top of the plastic turbine assembly.
As shown in photo below.
Page 5 of 7
Copyright © 2006 Quality Water Treatment, All right reserved. www.qualitywatertreatment.com
