Screwing valve onto tank.
Make a list of all the plumbing fittings you will need to completely install the unit to make
it ready for operation.
Typical is:
•
Two - 3/4" male adaptors
•
Eight - 90% elbows
•
The amount of pipe you need
•
1/2" drain line and 90% elbows
Assemble all tools needed to install the unit. Start your Installation. If copper, you need a
copper cutter, propane tank, soldering torch, flux, wire paper and lead free solder. An
average cost of $40.00
NOW THAT YOU HAVE ADDED THE RESIN AND ARE READY TO INSTALL, FOLLOW THESE
INSTRUCTIONS
1. Turn off the main water shutoff valve.
2. Open all plumbing fixtures in the house including all outside faucets in order to drain
the lines of all the water you can. We have found by unscrewing the aerator screen from
your kitchen and bathroom faucets help create more of a vacuum to drain the water out
of the lines faster
3. Cut and remove a 4" section of water line where the unit is to be installed if you have a
typical straight in and out connection.
Page 2 of 7
Copyright © 2006 Quality Water Treatment, All right reserved. www.qualitywatertreatment.com
