Fleck 3200 NT, Руководство пользователя

Страница: 30 / 78

3 - PROGRAMMATION 3200 NT
3200 NT
29
E
N
G
L
I
S
H
Meter size
This parameter allows indicating the meter size.
- Meter Fleck 1"
[FF1.0]
- Meter Fleck 1" 1/4 [FF1.2]
- Meter Fleck 1" 1/2 [FF1.5]
- Meter Fleck 2" [FF2.0]
- Meter Fleck 3" [FF3.0]
- Non Fleck meter [FF- - ]
Meter non Fleck
This parameter can be set when [FF- - ] is chosen.
This parameter allows setting the number of impulses generated for 1 litre of water.
- 36.3 pulses per litre
[F36.3]
Electrical frequency
This parameter allows indicating the electrical frequency. If it is set properly, the displayed time
will be accurate.
- 60 Hz
[ L F 6 0 ]
- 50 Hz [ L F 5 0 ]
Exit programming
After exiting programmation, CALc will be displayed to indicate that the volume is being
calculated. The time CALc will be displayed depends on the volume to calculate and can last
longer than a minute.
Time setting
Finish the programming by setting the time. With the display in service mode, use the and
buttons to set the time.
Caution: do not press the regeneration button after setting the time or a regeneration can be
triggered.
Programmation menu check according to the system type. An “X” indicates that the parameter
is available.
1.21
1.22
1.23
Note: the three first parameters are not mentioned in the chart below.
Parameters 4tc 4fi 4fd 5fi 6 & 7 6 & 7 9fi
Valve position (Lead or Lag) Lead/Lag Lead Lag Lead/Lag
Remote regeneration triggering (rSoF) X X X X
Displayed unit (U – x ) X X X X X X X
System capacity (Cxxx) X X X X X X
Safety coefficient X X X X X X
Inlet water hardness (Hxxx) X X X X X
Regeneration time (xx : xx) X X X X X X X
Calendar forcing (Axxx) X X X X X X X
Regeneration cycle time (1- xx, 2- xx, 3 –xx,etc) X X X X X X X
Auxiliary outlet during regeneration (Arof) X X X X X X X
Auxiliary outlet for dosing pump (cPOF) X X X X X
Meter size (FFxx) X X X X X
Electrical frequency (LFxx) X X X X X X X
2
3