Flavor Burst JBT Series, Руководство по эксплуатации

Страница: 28 / 43

26
Priming Functions
The priming functions fills the syrup line with
new or fresh syrup. This is typically done when
switching flavors and after the syrup line has
been flushed with sanitizer solution (see
“Flushing Functions” above). It is also done to
prime the lines with fresh syrup, since syrup
can lose its flavor if it has been sitting in the
syrup line for a few days without use.
1. Press the “Priming Functions” section in the
Maintenance Menu.
2. Place a container under the spout to catch
the purged syrup.
3. Select the flavor of the syrup line you are
priming. The button will pulse as syrup is
pumped through the line. Keep priming
the line until the syrup is running fresh and
undiluted.
4. The prime function will shut off automatically
after a preset time. To stop the prime
function early, press the flavor button again
to cancel the function. You may need to
press the button more than once to make
sure the line is fully primed.
Grape
26251
NOTE: WHILE THE PRIME FUNCTION IS
ACTIVE, YOU WILL NOT BE ABLE TO
PERFORM OTHER FUNCTIONS ON THE
JUMBO TOUCH PANEL.
NOTE: TO CHANGE THE LENGTH OF TIME
THE PRIMING PROCEDURE RUNS, SEE
“FLUSHING AND PRIMING SETTINGS” OF
THE MAINTENANCE MENU.
5. When no additional flavors need to be
installed, draw a serving to clear the door
spout opening of any residual flavor.
26211
6. If there is more than one spout dispensing
Flavor Burst, press the green CHANGE
SPOUT button to access that spout’s syrup
lines.
(spout 2)