Flavor Burst CTP 44BEV, Дополнение к руководству по эксплуатации

Страница: 56 / 60

55
Testing the Drive Motor and Switch
Connections
Test the system to ensure the Color Touch
Panel is set up to operate each flavoring
assembly on the correct freezer spouts. If the
Equipment Setup Wizard is not set up correctly
or if the Drive Motor cables are not connected
to the right ports on the back of the cabinet, you
may try to draw a serving on one spout, and
find that the system is activating the flavoring
assembly on the opposite spout.
1. To test if the Drive Motors are connected to
the correct spouts, activate the spigot switch
by lifting the draw handle pin on one spout.
This should activate the motor attached to
this spout. Test the motor on the other
spout.
26109
NOTE: THE FCB FLAVORING ASSEMBLY
DOES NOT HAVE A MOTOR. SELECT A
FLAVOR AND DRAW A SERVING TO
DETERMINE IF THE SWITCH AND FLAVOR
LINES ARE CONNECTED TO THE SPOUT
YOU ARE DRAWING FROM.
2. If the Drive Motor on the other spout
activates, check the following areas:
3. Ensure the Drive Motor cable is connected
to the correct port at the back of the unit.
Typically, the motor installed on the freezer
to your left is connected to port “1”.
4. Go to the Color Touch Panel’s
“Maintenance Menu” and go through the
Equipment Setup Wizard. On “Step 4” of the
Equipment Setup Wizard, assign a spout to
the injector connectors C and D on the
board. If “Spout 1” is the freezer spout on
your left, and that motor cable is connected
to the “1” port at the back of the unit, ensure
that the Spout 1 is assigned to “Connector
C”. “Connector D” is linked to the cabinet
port labeled “2” and should be connected to
the Drive Motor on your second freezer
spout.
5. Also while in the Equipment Setup Wizard,
check the switch port assignments. Switch
Port 1 is the port to the inside of the panel
and Switch Port 2 is the one to the outside
of the panel. See which port is connected
to your first spout, and ensure the screen is
shows that connection. Do the same for the
second port and spout connection.
6. Repeat Step 1. If there is still a mix up in
the Drive Motor signals, you may be able to
correct it by switching the Drive Motor
cables around on the ports at the back of
the cabinet, or swap the ports the switches
are connected to on the Color Touch Panel.
If neither of those solutions work, contact
your local distributor for help.