Supplied By www.heating spares.co Tel. 0161 620 6677
9
d) The gas supply can be bought in to the firebox from either the left-hand rear or the left-hand
side.
e) Carefully withdraw the firebox from the opening to enable the gas supply and fire fixing to be
completed.
f) The inlet pipe should be connected to the isolating / inlet elbow of the appliance using 8mm
rigid or semi-rigid metal tubing. There must be no soldered joints within the firebox.
Note : Before breaking into the gas supply a pressure drop test should be carried out to
establish that the existing pipework is sound.
Depending on the spacer option selected, (flush fit or 3” black spacer) there is a choice of methods
of fixing the firebox which are provided to enable the installer to deal with any type of installation.
The preferred method of fixing which is suitable for almost all situations is the cable fixing
method which is described in the following section in detail.
The other methods are listed below.
1)
If flush fit option is used, the fire may be secured using the cable method as
Described below, or alternatively, in installations where the cable method is not suitable (eg.
loose masonry in rear of fire opening), the fire can be secured to the fire surround using
four screws and wall plugs through the holes provided.
2)
If the 3” black spacer is used, secure fire box to spacer using 4off M5 x 6 screws. Make
sure there is a good seal between the firebox and spacer and spacer and surround.
To fit using the preferred cable method proceed as follows-
g) Mark out and drill 4 off No 14 (6mm) holes in the back face of the fire opening in the positions
shown below.
Centreline
100
500
50
Fire opening
Hearth
160
