Flashforge THOR300T, Быстрый старт, Страница: 13 / 40

12
Base line
1. Tighten the four nuts of the build plate
counterclockwise
2. Measure the height from the left side of the
X-axis to the bottom section with a ruler.
Base the height on the left, the height shall
not be lower than 120mm.
3. Then measure the height from the right side
of the X-axis to the bottom section. Both sides
must be of the same height. 4. Manually rotate the coupling under the screw
rod, adjust it and make sure both sides be at
the same height.
5. Insert power cable into supply socket on the
left of the printer. 6. Insert the power plug into supply socket, and
open the power switch.
Leveling Build Plate