Flashforge Guider 3, Руководство пользователя

Страница: 26 / 56

24
Scheme 1: Increasing the platform temperature can effectively alleviate this
problem, as the high temperature can increase the adhesion between
the platform and the model.
Scheme 2: Choosing to add a raft when slicing the model can effectively alleviate
this problem.
Scheme 3: Apply glue.
Scheme 4: If the distance between the nozzle and platform is too large, it should
be reduced accordingly, which can be done via the expert mode of
extruder calibration and the calibration function.
Scheme 5: Confirm whether the platform is laid flat. The calibration function can
be used, and it is recommended to perform a full-process automatic
leveling.
Q10: The printed model is warping or not sticking well. How to deal
with this situation?
Not necessarily. When printing the raft, the filament extrusion amount is larger
and the printing success rate is higher. Under the condition of raft heating, the
adhesion between the model and the platform plate increases, which makes the
model adhere to the platform well when printing, and also increases the printing
success rate.
Q11: Must a raft be added when printing a model?
The format of the USB flash drive is incorrect. The equipment supports FAT32 file
system. Please format the USB flash drive into FAT32 format.
Q12: After inserting the USB flash drive, the print file can not be found,
and the screen displays all as folders. How to deal with this
situation?
1. Please check whether the Wi-Fi name contains special characters. If so, please
modify it and try again;
2. Please check whether the password contains special characters. If so, please
modify it and try again.
Q13: How to deal with Wi-Fi connection failure?
Please do not disconnect the power and the network when downloading or
updating the firmware to avoid update failure.
Q14: What are matters needing attention in updating the firmware?
If the start-up sound can be heard, please replace the screen or the flat cable;
If not, please contact our after-sales personnel.
Q15: Why is the boot screen white?
It is a normal phenomenon. The guide rails come with lubricating oil, and
yellowish-brown stains will appear when the guide rails are used for a long time.
Q16: Is it normal that yellowish-brown stains appear on the guide
rails after a long time of use?
It is a normal phenomenon. The faster the printing speed is, the more obvious
the shaking of the machine will be.
Q17: Is it normal for the machine to shake during printing?