FLASHFORGE 3D PRINTER CREATOR PRO 2, Руководство пользователя

Страница: 52 / 56

Chapter 4: Maintenance
Problem Cause Corrective Action
Extruder head building off
center.
The device has lost track of
extruder’s exact location
and is failing to build.
Send the extruder to the
home position will recali -
brate Creator Pro 2. Cancel
your object, clear build
plate,send the extruder to
the home position, and
restart the object.
PLA is not extruding or
sticking to the build tape
properly.
This can be caused by the
platform not being
leveling with the extruder
head.
Leveling the platform will
align the extruder head
and ensure a better object
quality. Cancel your
object, clear build
platform, level the build
platform, and restart the
object.
Creator Pro 2 froze before
my object started.
Creator Pro 2 may have
received contradictory
commands.
Turn power switch off,
wait 30 seconds, and turn
power switch on.
Spaghetti mess at end of
build.
A layer of your object did
not stick properly, model
was saved with minimal
surface area contacting
the build platform, or
object was built floating
above the build platform
with no support selected.
Z axis offset may not be
correct and the extruder
tip is not properly spaced
with the build platform.
Use the preview feature in
your slicing software to
see the first layer height
and position. Build with
supports when necessary.
Contact customer service
on how to calibrate the Z
axis Offset.
No filament coming out. Clogged extruder.
Filament not properly
loaded.
Contact customer service.
Try running the filament
change again to ensure the
extruder gears have
properly caught the lament.
Extruder will not home. Limit switch wire failure Contact customer service.
Stringy or fraying plastic
layers on steep
overhangs.
Object overhangs are too
far apart or too steep (Less
than 45 degree angle).
Build with supports.
50