www.flash-butrym.pl
4
2.
Power (in/out): powerCON socket
5.1
Connecting DMX signal
The
connection
is
performed
using
cable
with
XLR-female
->
XLR-Male
plugs.
CAUTION: At the last fixture, the DMX signal has to be terminated with a terminator. Solder a 120
resistor
between signal (-) and signal (+) into a XLR plug and plug it in the DMX output of the last fixture.
5.2
Voltage specification
Input Voltage
Total Power
Frequency
100~240V
330W
50/60Hz
5.3
Connecting power supply
The connection is performed using power cable with PowerCon connector (included).
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
CAUTION!
In the case of cable damage do not attempt to repair. Replacement or repair can be made only
on the manufacturer or by a person with appropriate permissions.
