Manual external FLARM™ / PowerFLARM™ Display V3+Mm
External FLARM™/ PowrFLARM™
Display V3+Mm
with Software-version 3.7
Page
8
Wiring to “FLARM
TM
”
For electrical connection the provided cable is
connected to the jack of the external display and
RJ12-jack of FLARM.
To connect FLARM with the Hardware version 1
(2004),
only one jack (RJ45) is on the rear side. In order to
connect the power supply cable along with the
connection to the external display, a Y-adapter
(RJ45, 8-pole) is required.
Wiring to “PowerFLARM
TM
PORTABLE”
The V3+ display has a 6-pole RJ12-jack,
PowerFLARM
TM
has a 8-pole RJ45-jack.
Signal allocation of both jacks is compatible with
the 6-core cable from the display and can be
attached in the RJ45 plug; this means that the RJ45
plug pins 1 and 8 are rendered free.
Wiring to “PowerFLARM
TM
CORE”
The PowerFLARM
TM
CORE is connected in similar fashion as the portable PowerFLARM
TM
. The CORE has
another independent data interface at the DSUB-9 jack; this allows a possible connection to the display.
Two-seater version
Using the Y-adapter (RJ12. 6-pole) two external
displays can be operated on FLARM
TM
or
PowerFLARM
TM
.
In order to avoid data collisions while operating
both displays, one of the displays must be
configured as “PAX” (refer to operation manual).
All FLARM and display versions function in
combination with each other.
Other variations…
The connection options are versified, apart from the displays to FLARM
TM
which can be connected to PDA
or navigation computers. If uncertain with connections, consult the manuals of the FLARM
TM
-devices or
contact their distributor.
Tip:
The Y-adapter RJ12 (3 jacks) and RJ45 (2 jacks / 1 plug) are normally found as commercial phone
accessories; please note with RJ12 that all 6 poles have their contacts. In commercial use the 4-pole
RJ11 versions are often only found.
6-core cable
… from hardware version 2
(*) FLARM hardware version 1 does
not have any “extension” interface
6-core cable
6-core cable
6-core cable
Содержание FLARM V3+Mm
Страница 20: ......