Flare Fireplaces Flare Corner Right & Left 30-100", Руководство по установке

Страница: 98 / 102

98 | P a g e
MAXITROL TROUBLESHOOTING GUIDE FOR SAFETY SCREEN
No response from unit to remote power on function.
Ensure power button is pressed for 3 seconds.
Receiver (see figure 1) must learn new code:
•
Press and hold the receiver’s reset button (Figure 2) until you hear 2 acoustic signals. After the second longer acoustical
signal, release the reset button and within the subsequent 20 seconds, press (down arrow) and hold on the remote
handset until you hear an additional long acoustic signal confirming the new code is set.
•
NOTE: if 15-20 seconds pass while pressing and holding (down arrow) and a long single tone is heard, confirm the
sticker label (see below) on the remote handset and back of the receiver are both blue, or remote sticker is black, and
the receiver sticker is green.
Dead batteries/no batteries.
Bent pins on 8 wire connectors.
•
Inspect and straighten pins as needed.
Receiver is surrounded by metal, reducing the transmission range.
•
Bring remote closer to unit for troubleshooting.
•
Limited range of the remote due to local RF transmission.
•
Change the position of the antenna.
Receiver is bad.
Remote is bad.
•
Ensure labels on back of remote and receiver match in color. Blue and blue, green to black.
•
Replace remote if needed and reprogram code.
No Ignition; No Tone:
See above to ensure remote has correct code to receiver.
Check power to receiver.
Receiver bad.
No Ignition; One continuous 5 second tone (7 short beeps might be heard prior to the 5 second tone):
Loose wire.
Bent pins on 8 wire connectors.
Reset receiver and resync remote.
Receiver.
Valve.