FLAMMA EF172D, Инструкция по эксплуатации

Страница: 45 / 160

45
EXPANDED SETTINGS
In day and week mode, press . To switch off the heater when the heater is on
during a preset heating period. To switch on the heater when the heater is off
between preset heating times.
CUSTOMISED START-UP CONTROL
Depending on the room temperature and the target temperature, the heater
switches on automatically to heat the room to the set temperature at the set
time. For example, if your timer is set to 6:00 p.m. and the temperature is set
to 23 °C, the heater will switch on at 5:30 p.m. to ensure that the room is 23 °C
at 6:00 p.m.
OPEN WINDOW DETECTION
If the transmitter detects a rapid drop in room temperature, this is interpreted
as an open window. A warning symbol is displayed and the heater is auto-
matically switched off. After the indoor temperature has risen or a manual
override of the warning has been made (by using the remote control), the unit
returns to normal operation.
RESETTING THE THERMAL CUT OUT
The appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance over-
heats, e.g. when covered. If the heater stops operating while the flame effect
continues working normally, this indicates that the E.S. Control is in operation.
The E.S. Control can only be re-set after the appliance has cooled down,
and the appliance has been reset. Re-setting of the E.S. Control proceeds is
as follows:
1. Switch off the appliance (Manual On / Off switch) and leave it off for
approximately 10 – 15 minutes.
2. Remove any obstruction to the fan heater outlet or fan blades etc.
Make sure that the power supply is disconnected with the plug socket
outlet while doing this.
3. Switch on the appliance and the E.S. Control will be re-set.
4. Ensure that the appliance is functioning correctly. If the E.S. Control
doesn't operates again, the appliance should be checked by a
competent electrician.
EN